![]() ![]() Press the seT button again and hold it down and press the pRog button, too.Īt this point the device gets into programming mode and the numbers indicating the days of the week (1 2 3 4 5 6 7) are flashing on the display.Īt this point the next programming step should be performed, i.e.Īs in the previous steps, the time value to be set will flash on the display. To prevent the pump from sticking, the activated pump protection function switches on the boiler for a one minute period at 12:00 p.m. Using the large.or.button on the front panel of the device, set the serial number of the current day (Monday 1.īy pressing the ReseT button, the pipe protection function is reset to factory default setting (HP:OFF). Computherm Wireless Thermo Control System User Serial Number Of It is reasonable to locate it in a room used regularly or for many hours per day so that it is in the direction of natural ventilation in the room but protected from drought or extreme heat (e.g. The switching sensitivity of the thermostat can be selected: 0.2C (factory default setting, recommended for radiator-based heating systems) or 0-0.2C (this setting is recommended for underfloor heating). Computherm Wireless Thermo Control System User Install The Receiver.Computherm Wireless Thermo Control System User Serial Number Of. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |